Home - Return to Previous Page
Exhaust Header System, TorqueTubes Exhaust Headers and Y-pipe with hardware, for 1989-1993 Ford F250/F350 7.5L, 460 Truck, Manual Transmission
Exhaust Header System TorqueTubes Exhaust Headers and Y-pipe with hardware for 1989-1993 Ford F250/F350 7.5L, 460 Truck, Manual Transmission
48814
Virtually indestructible, unleashes greater torque
Virtually indestructible 100% stainless TorqueTubes maximize exhaust extraction, unleashing gobs of torque that'll jam you into the seat and haul you up the grade. Includes two full exhaust manifold assemblies, each with a seamless high-velocity collector. Unlike the restrictive stock setup, Banks TorqueTubes literally pull out the exhaust, unleashing greater torque and helping the intake stroke to draw in more air.
US Patent #6,634,171 B1
50 State Compliant:
CARB E.O. D-161-41
Non-Air Injection 4-bolt catalytic converter flange inlet .Manual transmission F-350 4x4 requires sway bar bracket #48899
Virtually indestructible 100% stainless TorqueTubes maximize exhaust extraction, unleashing gobs of torque that'll jam you into the seat and haul you up the grade. Includes two full exhaust manifold assemblies, each with a seamless high-velocity collector. Unlike the restrictive stock setup, Banks TorqueTubes literally pull out the exhaust, unleashing greater torque and helping the intake stroke to draw in more air.
CARB E.O. D-161-41
Was:
$1,298.89
Sale:
$1,169.00
Save:
10%
Save:
$129.89
Description
TORQUETUBES® MANIFOLD ASSEMBLY
Banks' 100% stainless TorqueTubes are virtually indestructible. Includes two full exhaust manifold assemblies, each with a seamless high-velocity collector. Unlike the restrictive stock setup, Banks TorqueTubes literally "pull" out the exhaust, unleashing greater torque and helping the intake stroke to draw in more air.
- Virtually indestructible 100% Stainless Steel
- Mandrel-formed tubes tune exhaust flow for maximum torque
- Maximize exhaust extraction
- Flanges welded on both sides, then milled flat
- Seamless high-velocity collector
- Pulls exhaust and slashes backpressure
- Includes two full manifolds & stainless Y-pipe
- 5/8 inch thick flanges won't warp/flex
- No sealant/gaskets needed
- No need for factory heat shields
- Runs cooler to protect expensive plug wires
Emissions Compliant: D-161-41
US Patent #6,634,171 B1
Details
- 48814
- 48814
- 801279488144
- Banks Power
- New
Shipping Information
- Item Requires Shipping
- 69.0 lbs.
- W24.0000” x H11.0000” x L43.5000”
